Engine/automatic transmission assembly - reconnection and refitting

1 Reverse the procedure described in Section 11, noting the following points.

2 Check that the engine adapter plate is correctly positioned on its locating dowels.

3 As the torque converter is only loosely engaged in the transmission, care must be taken to prevent the torque converter from falling out forwards. When the torque converter hub is fully engaged with the fluid pump drivegear in the transmission, distance УAФ in illustration 2.24 of Chapter 7B must be as specified. Incorrect installation of the torque converter will result in damage to the transmission.

4 As the engine and transmission are reconnected, guide the torque converter studs through the holes in the driveplate.

When the engine is positioned flush with the engine adapter plate and the transmission housing, check that the torque converter is free to move axially a small amount before refitting and tightening the engine-totransmission bolts.

5 Do not tighten the torque converter-todriveplate nuts until the lower engine-totransmission bolts have been fitted and tightened.

6 Reconnect and adjust the selector rod.

7 Fill the engine with the correct grade and quantity of oil.

8 Fill the cooling system.

9 Check and if necessary top-up the transmission fluid level.

10 Check and if necessary adjust the tension of the alternator drivebelt.

11 Adjust the throttle cable.

12 Where applicable, adjust the kickdown cable.

    See also:

    General information
    Have your vehicle serviced regularly to help maintain its roadworthiness and resale value. There is a large network of Ford Authorised Repairers that are there to help you with their professional ...

    Waxing
    Х Wash the vehicle first. Х Use a quality wax that does not contain abrasives. Х Do not allow paint sealant to come in contact with any non-body (low-gloss black) colored trim, such as grained door ...

    Load apportioning valve P100 models) - removal and refitting
    Caution: Refer to the precautions in Section 1. Removal 1 Chock the front wheels, jack up the rear of the vehicle and support on axle stands (see УJacking and Vehicle SupportФ). 2 The load appor ...