Spark control system components (carburettor models) - removal and refitting

Spark delay and sustain valves 1 Disconnect the vacuum pipes at the valve and withdraw the valve.

2 When refitting a spark delay valve, the valve must be positioned with the black end (marked CARB) towards the carburettor and the coloured end (marked DIST) towards the distributor or electronic module (as applicable).

3 When refitting a spark sustain valve, the valve must be positioned with the end marked VAC towards the carburettor and the side marked DIST towards the distributor or electronic module (as applicable).

Ported vacuum switch
4 Where fitted, the switch(es) may be located in the inlet manifold and/or in an adapter fitted in one of the coolant hoses.

5 To remove a switch, partially drain the cooling system. Note that there is no need to remove the cylinder block drain plug.

6 Mark the vacuum pipes for location so that they can be refitted in their correct positions, then disconnect the pipes from the switch.

7 Unscrew the valve from its location.

8 Refitting is a reversal of removal, ensuring that the vacuum pipes are correctly connected. Refill the cooling system.

Fuel trap
9 Disconnect the vacuum pipes at the fuel trap and withdraw the fuel trap.

10 When refitting, the fuel trap must be positioned with the black end (marked CARB) towards the carburettor, and the white side (marked DIST) towards the distributor, electronic module, or ported vacuum switch (as applicable) (see illustration).

22.10 Fuel trap vacuum connection markings
22.10 Fuel trap vacuum connection markings

Spark control system additional components
11 According to model, engine and equipment, additional components such as one-way valves or solenoids may also be fitted as part of the spark control system.

12 The removal and refitting procedures for these components are basically as described previously, and provided that all attachments are marked for position prior to removal, no problems should be encountered.

    See also:

    Driveshaft check (Every 12 000 miles or 12 months)
    1 Carry out a thorough inspection of the driveshafts and joints as follows. 2 Jack up the front of the car and support it securely on axle stands (see Jacking and Vehicle Support). 3 Slowly rot ...

    Wheel sensor (ABS) - removal and refitting
    Note: A new O-ring must be used when refitting a sensor. Front wheel sensor 1 Apply the handbrake, loosen the relevant front roadwheel nuts, then jack up the front of the vehicle and support on a ...

    Child seat positioning
    WARNINGS: When using a child restraint with a support leg on a second row seat, make sure the support leg rests securely on the floor. When using a forward facing child seat on a second row seat ...