General information

WARNINGS:
Use load securing straps to an approved standard, e.g. DIN.

Make sure that you secure all loose items properly.

Place luggage and other loads as low and as far forward as possible within the luggage or loadspace.

Do not drive with the tailgate or rear door open. Exhaust fumes may enter the vehicle.

Do not exceed the maximum front and rear axle loads for your vehicle.

See Vehicle identification.

CAUTIONS:
Do not allow items to contact the rear windows.

Do not use any abrasive materials to clean the interior of the rear windows.

Do not install stickers or labels to the interior of the rear windows.

    See also:

    Door exterior handle - removal and refitting
    Removal 1 Remove the door inner trim panel. 2 Where necessary for improved access, peel back the waterproof plastic sheet from the door. 3 If working on a front door, remove the window channel ex ...

    Throttle pedal - removal and refitting
    Removal 1 Disconnect the battery negative lead. 2 Remove the lower facia panel from the driver’s side. 3 Prise off the securing clip and disconnect the end of the throttle cable from the top of ...

    Direction indicator and hazard warning flasher switch assembly - renewal
    1 Disconnect the battery negative lead. 2 Remove the securing screws and unclip the lower and upper steering column shrouds. 3 Remove the two securing screws and disconnect the two wiring plugs, t ...