Tailboard (P100 models) - removal and refitting

Removal
1 Lower the tailboard to the open position.

2 Detach the rear lamp wiring cover on one side of the vehicle by removing the two securing screws (see illustration).

24.2 Rear lamp wiring cover screws (A) and tailboard hinge screws (B)
24.2 Rear lamp wiring cover screws (A) and tailboard hinge screws (B)

3 Remove the four rear lamp securing nuts, and withdraw the rear lamp assembly.

Disconnect the wiring plug.

4 Raise the tailboard by approximately 20º, lift the centre pivot of one of the support arms, and when the bolt head on the tailboard is aligned with the slot in the support arm, pull the support arm clear. Repeat this procedure for the remaining support arm, and lower the tailboard to the vertical position.

5 On the side of the vehicle from which the rear lamp has been removed, remove the two screws securing the tailboard hinge to the cargo area.

6 Close the tailboard and lever out the hinge.

7 Pull the free end of the tailboard away from the cargo area, and carefully prise the remaining end from its hinge. Withdraw the tailboard from the vehicle.

8 If required, the pivot bushes can be removed from the tailboard for renewal.

Refitting
9 Refitting is a reversal of removal.

    See also:

    Using winter tyres
    CAUTION: Make sure that you use the correct wheel nuts for the type of wheel the winter tyres are fitted to. If winter tyres are used, make sure that the tyre pressures are correct. See Technica ...

    Braking system
    The braking system is of the dual circuit hydraulic type with disc brakes at the front and drum brakes at the rear. A diagonally split dual circuit hydraulic system is employed in which each circu ...

    Engine oil check
    CAUTION: Do not use oil additives or other engine treatments. Under certain conditions, they could damage the engine. Note: The oil consumption of new engines reaches its normal level after app ...