Speedometer cable - removal and refitting

Removal
1 On models fitted with a trip computer, remove the speed sender unit.

2 Remove the instrument panel.

3 Pull the cable through the bulkhead into the engine compartment, and where applicable release it from the securing clips. On models fitted with a trip computer, the upper section of the cable can now be removed.

4 Apply the handbrake, jack up the front of the vehicle and support on axle stands (see “Jacking and Vehicle Support”).

5 On vehicles with a manual gearbox, extract the circlip securing the cable end to the extension housing and withdraw the cable end (see illustration).

30.5 Speedometer cable end fitting in manual gearbox extension housing
30.5 Speedometer cable end fitting in manual gearbox extension housing

6 On vehicles with automatic transmission, remove the securing screw and disconnect the cable end from the extension housing.

7 The cable can now be withdrawn from the vehicle, noting its routing so that it can be refitted in the same position.

Refitting
8 Refitting is a reversal of removal, but where applicable, ensure that the speedometer cable rubber sleeve is in place over the square inner drive on the cable connector, and not in the speedometer head. Position the cable so that the coloured bands on the cable sheath line up with the bulkhead grommet and the clips in the engine compartment. Route the cable as noted during removal.

9 On completion, pull the speedometer cable from within the engine compartment to ensure that the cable is straight between the instrument panel and the bulkhead grommet.

    See also:

    Fuel tank - removal and refitting
    The procedures are the same as described in Part A of this Chapter for carburettor engines, but in addition disconnect the fuel tank-to-fuel pump hose from the rear face of the tank. ...

    Heater - removal and refitting
    Removal 1 Disconnect the battery negative lead. 2 Refer to Chapter 11 and remove the centre console. 3 Working within the engine compartment, disconnect the coolant hoses from the heater pipe st ...

    Cold start valve - removal and refitting
    Note: Refer to the precautions at the end of Section 1 before proceeding. K-Jetronic system Removal 1 Disconnect the battery earth lead. 2 Detach the electrical wiring multi-plug from the valve ...