Front foglamps - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
2 Remove the relevant front direction indicator lamp unit.

3 Release the retaining catch on the inside edge of the lamp, then withdraw the lamp from the bumper and disconnect the wiring plug (see illustration).

46.3 Front foglamp removal - models up to 1987
46.3 Front foglamp removal - models up to 1987

A Retaining catch

4 Refitting is a reversal of removal.

Models from 1987
5 Remove the two securing screws, then withdraw the lamp forwards and disconnect the two wiring plugs.

6 Refitting is a reversal of removal, but where necessary use a new gasket between the lamp and bumper.

7 On completion, the vertical alignment of the foglamp must be adjusted. For the foglamps, dimension “X” (see illustration, 42.4) should be taken as 220.0 mm (8.7 in). The adjuster screw is located on the inside edge of the lamp above the securing screw (see illustration).

46.7 Front foglamp adjuster screw (A) and securing screws (B) - models from
46.7 Front foglamp adjuster screw (A) and securing screws (B) - models from 1987

    See also:

    Bodywork and fittings
    The body is of welded steel construction available in 3 or 5-door Hatchback, 3 or 5- door Estate, soft-top Cabriolet, or Van configurations. The body is of monocoque construction and is of energy ...

    Using hill start assist
    The system can operate in either automatic or manual mode. If you select automatic mode, the system is activated automatically when the vehicle is on a slope and you press the brake pedal. If you ...

    General information
    Have your vehicle serviced regularly to help maintain its roadworthiness and resale value. There is a large network of Ford Authorised Repairers that are there to help you with their professional ...