Changing the remote control battery

Make sure that you dispose of


Make sure that you dispose of old batteries in an
environmentally friendly way.

Seek advice from your local authority regarding recycling.

Remote control with a folding key blade
Remote control with a folding key blade

1. Insert a screwdriver as far as possible into the slot on the side of the remote control, push it towards the key blade and remove the key blade.

2. Twist the screwdriver in the position


2. Twist the screwdriver in the position shown to start separating the two halves of the remote control.

3. Twist the screwdriver in the position


3. Twist the screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

Remote control without a folding key blade

Type 1
Type 1

1. Insert a screwdriver into the recess on the back of the key and remove the key blade.

2. Release the retaining clips with the screwdriver and separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

3. Carefully prise out the battery with the screwdriver.

4. Install a new battery (3V CR 2032) with the + facing upwards.

5. Assemble the two halves of the remote control.

6. Install the key blade.

Type 2
Type 2

1. Slide the release slider in the direction of the arrow.

2. Remove the key blade.

3. Twist a flat bladed screwdriver in the


3. Twist a flat bladed screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

Type 3
Type 3

1. Press and hold the pushbuttons on the edges to release the cover.

Carefully remove the cover.

2. Remove the key blade.

3. Twist a flat bladed screwdriver in the


3. Twist a flat bladed screwdriver in the position shown to separate the two halves of the remote control.

4. Carefully insert the screwdriver in the


4. Carefully insert the screwdriver in the position shown to open the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

5. Carefully prise out the battery with the screwdriver.

6. Install a new battery (3V CR 2032) with the + facing downwards.

7. Assemble the two halves of the remote control.

8. Install the key blade.

    See also:

    About this handbook
    Thank you for choosing Ford. We recommend that you take some time to get to know your vehicle by reading this handbook. The more that you know about it, the greater the safety and pleasure you wi ...

    Fuel vapour separator (models from 1985) - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. Removal 1 On SOHC models, the vapour separator is located on the left-hand side of the engine compartment. On CVH models, the va ...

    Rear suspension leaf spring shackle (P100 models) - removal and refitting
    Note: All self-locking nuts and spring washers must be renewed on reassembly. Removal 1 Chock the front wheels, jack up the rear of the vehicle and support on axle stands placed under the side me ...