Electromagnetic compatibility

WARNINGS:
Your vehicle has been tested and certified to European legislations relating to electromagnetic compatibility (2004/104/EC). It is your responsibility to ensure that any equipment you have fitted complies with applicable local legislations. Have any equipment fitted by properly trained technicians.

Radio frequency (RF) transmitter equipment (e.g. cellular telephones, amateur radio transmitters etc.) may only be fitted to your vehicle if they comply with the parameters shown in the table below. There are no special provisions or conditions for installations or use.

Do not mount any transceiver, microphones, speakers, or any other item in the deployment path of the airbag system.

Do not fasten antenna cables to original vehicle wiring, fuel pipes and brake pipes.

Keep antenna and power cables at least 100mm from any electronic modules and airbags.


1 Only for GSM/3G cellular phones, with a patch antenna installed inside of1 Only for GSM/3G cellular phones, with a patch antenna installed inside of


1 Only for GSM/3G cellular phones, with a patch antenna installed inside of the front
windscreen.

Note: After the installation of RF transmitters, check for disturbances from and to all electrical equipment in the vehicle, both in the standby and transmit modes.

Check all electrical equipment: Х with the ignition ON.

Х with the engine running.

Х during a road test at various speeds.

Check that electromagnetic fields generated inside the vehicle cabin by the transmitter installed do not exceed human exposure limits specified in EU directive 2004/40/EC.

    See also:

    Starting a petrol engine
    Note: You can only operate the starter for a maximum of 30 seconds at a time. Cold or hot engine All vehicles CAUTION: When the temperature is below -20ºC (-4ºF), switch the ignition ...

    Cylinder head - removal and refitting
    Removal Note: On HCS engines, cylinder head bolts may be used a total of three times (including initial fit) and must be suitably marked to indicate each removal operation. A new cylinder head ga ...

    Clock
    Note: Some navigation systems will automatically set the date and time on the clock using GPS signals. Note: See General information. 1. From the main menu, select the clock function. 2. Select ...