Hints on driving with ABS

When the ABS is operating, the brake pedal will pulse. This is normal. Maintain pressure on the brake pedal.

The ABS will not eliminate the dangers inherent when:
Х you drive too close to the vehicle in front of you.

Х the vehicle is aquaplaning.

Х you take corners too fast.

Х the road surface is poor.

    See also:

    Front hub bearings - renewal
    Note: A new driveshaft nut, and a new tie-rod balljoint split-pin must be used on refitting. 1 Remove the wheel trim and release the staking on the driveshaft retaining nut using a suitable punch. ...

    Final drive oil level check (Every 12 000 miles (20 000 km) or 12 months)
    1 Check the final drive oil level as follows. 2 Position the vehicle over a pit, or raise it at front and rear on ramps or axle stands. The vehicle must be level. 3 Wipe clean around the final dri ...

    Manual seats
    Moving the seats backwards and forwards WARNING: Rock the seat backwards and forwards after releasing the lever to make sure that it is fully engaged in its catch. Adjusting the lumbar suppo ...