Using the speed limiter

The system is operated by adjustment controls mounted on the steering wheel.

Press button A to switch the system on and off. The information display will prompt for a speed to be set.

Note: The set speed limit can be intentionally exceeded for a short period if required, for example when overtaking.

Setting the speed limit


Setting the speed limit

Use the cruise control switches to alter the maximum speed setting.

Press the SET+ switch or the SETswitch


Press the SET+ switch or the SETswitch to select your desired speed limit.

The speed is indicated in the information display and stored as the set speed.

Press button B to cancel the limiter and place it in standby mode. The information display will confirm deactivation by showing the set speed crossed out.

Press the RES button to resume the


Press the RES button to resume the limiter. The information display will confirm the system is active by showing the set speed again.

Intentionally exceeding the speed limit

Depress the accelerator hard close to the full pedal travel and the limit will temporarily deactivate. The system will reactivate once the vehicle speed drops below the set speed.

System warnings

If the set limit is accidentally exceeded the information display will show the set speed flashing together with an audible warning chime.

If the set limit is intentionally exceeded the information display will show the set speed crossed out.

    See also:

    Power steering fluid check
    Vehicles with 1.4L Duratec-16V (Sigma) or 1.6L Duratec-16V (Sigma) or 1.6L Duratec-16V Ti- VCT (Sigma) engine The fluid level should come up to the MAX mark when the engine is cold. If it drops b ...

    Electromagnetic compatibility
    WARNINGS: Your vehicle has been tested and certified to European legislations relating to electromagnetic compatibility (2004/104/EC). It is your responsibility to ensure that any equipment you ...

    Underbonnet lamp - removal, refitting and bulb renewal
    1 Disconnect the battery negative lead. Removal and refitting 2 Detach the wiring connector at the left-hand bonnet hinge, and attach a length of string to the end of the wire running from the lam ...