Load retaining fixtures

WARNING:
Do not exceed the maximum permissible load of 60 kilogrammes (132 pounds) on two load retaining fixtures and 30 kilogrammes (66 pounds) on one.

Check the security of the load retaining fixtures and tighten its fittings as follows: Х before starting.

Х after driving 50 kilometres (30 miles).

Х at 1 000 kilometres (600 miles) intervals.

Installing the load retaining fixtures
Installing the load retaining fixtures

Installing the load bracket

WARNINGS:
Install the load bracket with the longest section towards the rear of the vehicle. If you install it the wrong way round, it may not hold the box in place in the event of an accident.

Do not exceed the maximum permissible load of 20 kilogrammes (44 pounds).

1. Turn the box over.


1. Turn the box over.

2. Position the load bracket.

3. Secure the load bracket with four screws.

4. Slide the captured bolts onto the load


4. Slide the captured bolts onto the load retaining fixture.

5. Secure the load bracket with the two


5. Secure the load bracket with the two wing nuts.

6. Remove in the reverse order.

    See also:

    Determining if the Personal Safety System is operational
    The Personal Safety System uses a warning light in the instrument cluster or a back-up tone to indicate the condition of the system. Refer to the Warning lights and chimes section in the Instrument ...

    U.S. DOT Tire Identification Number (TIN)
    Both U.S. and Canada Federal regulations require tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characte ...

    Hydraulic unit pump and motor (ABS) - removal and refitting
    Note: New sealing washers must be used on the high pressure fluid hose banjo union, and a new O-ring must be used between the accumulator and the hydraulic unit on refitting. Caution: Refer to the ...