Erasing the Car2U Home Automation System buttons

Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the current settings using the procedure below and then reprogramming all of the devices being used.

To erase programming on the Car2U system (individual buttons cannot be erased), use the following procedure:

1. Firmly press the two outside Car2U system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons.

2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased.

If you sell your vehicle equipped with the Car2U system, it is recommended that you erase the programming for security reasons.

FCC and RSS-210 Industry Canada Compliance


    See also:

    Switching off traction control
    If the vehicle is stuck in snow, mud or sand, and seems to lose engine power, switching off the traction control features of the AdvanceTrac with RSC system may be beneficial because the wheels are ...

    Camshaft and cam followers - removal, inspection and refitting
    Note: A new camshaft oil seal should be used when refitting the camshaft. Removal 1 Remove the cylinder head. 2 Hold the camshaft stationary using a suitable spanner on the cast boss behind the ...

    Audio unit overview
    Note: Units have an integrated multi function display situated above the CD aperture. This shows important information regarding control of your audio unit. Additionally, there are various icons ...