Starting the engine

1. Turn the key to 3 (on) without turning the key to 4 (start). If there is difficulty in turning the key, rotate the steering wheel until the key turns freely. This condition may occur when:

• the front wheels are turned.

• a front wheel is against the curb.

2. Turn the key to 4 (start), then


2. Turn the key to 4 (start), then release the key as soon as the engine begins cranking. Your vehicle has a computer assisted cranking system that assists in starting the engine. After releasing the key from the 4 (start) position, the engine may continue cranking for up to 10 seconds or until the vehicle starts.

Note: Cranking may be stopped at any time by turning the key to the off position.

3. After idling for a few seconds, release the parking brake, apply the brake, shift into gear and drive.

Note: If the engine does not start on the first try, turn the key to the off position, wait 10 seconds and try Step 2 again. If the engine still fails to start, press the accelerator to the floor and try Step 2 again, keeping the accelerator on the floor until the engine begins to accelerate above cranking speeds; this will allow the engine to crank with the fuel shut off in case the engine is flooded with fuel.

    See also:

    Thermostat - removal and refitting
    1 Disconnect the battery negative lead. 2 Drain the cooling system. 3 Proceed as follows according to model: SOHC models 4 Disconnect the radiator top hose and expansion tank hose from the thermo ...

    Camshaft - removal and refitting
    Carburettor engines Note: Thread locking compound will be required to coat the camshaft sprocket bolt on refitting. Removal 1 Disconnect the battery negative lead. 2 Refer to the relevant Part o ...

    Ignition switch
    WARNING: Never return the key to position 0 or I when the vehicle is in motion. 0 The ignition is off. I The ignition and all main electrical circuits are disabled. Note: Do not leave the igni ...