Changing the remote control battery

Make sure that you dispose of


Make sure that you dispose of old batteries in an
environmentally friendly way.

Seek advice from your local authority regarding recycling.

Remote control with a folding key blade
Remote control with a folding key blade

1. Insert a screwdriver as far as possible into the slot on the side of the remote control, push it towards the key blade and remove the key blade.

2. Twist the screwdriver in the position


2. Twist the screwdriver in the position shown to start separating the two halves of the remote control.

3. Twist the screwdriver in the position


3. Twist the screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

Remote control without a folding key blade
Remote control without a folding key blade

1. Insert a screwdriver into the recess on the back of the key and remove the key blade.

2. Release the retaining clips with the screwdriver and separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

3. Carefully prise out the battery with the screwdriver.

4. Install a new battery (3V CR 2032) with the + facing upwards.

5. Assemble the two halves of the remote control.

6. Install the key blade.

    See also:

    Heated Exhaust Gas Oxygen (HEGO) sensor - removal and refitting
    Note: A new sealing ring will be required on refitting. Removal 1 Apply the handbrake, then jack up the front of the vehicle and support it on axle stands (see “Jacking and Vehicle Support”). 2 ...

    Rear number plate lamp - removal and refitting
    1 Disconnect the battery negative lead. Saloon, Hatchback and Estate models 2 To remove a lamp, simply prise it from the bumper using a thin-bladed screwdriver, and disconnect the wiring plug (se ...

    Air cleaner element renewal (Every 24 000 miles (40 000 km) or 2 years)
    Carburettor models 1 Remove the screws from the top of the air cleaner cover (see illustration). 38.1 Remove the air cleaner cover screws . . . 2 Where applicable release the spring clips aroun ...