Changing a bulb

WARNINGS:
Switch the lights and the ignition off.

Let the bulb cool down before removing it.

CAUTIONS:
Do not touch the glass of the bulb.

Only fit bulbs of the correct specification. See Bulb
specification chart.

Headlamp

Direction indicator

1. Remove the headlamp. See Removing a headlamp.

2. Remove the cover.


2. Remove the cover.

3. Turn the bulb holder anti-clockwise and remove it.

4. Gently press the bulb into the bulb holder, turn it anti-clockwise and remove it.

Headlamp dipped beam

1. Remove the headlamp. See Removing a headlamp.

2. Remove the cover.


2. Remove the cover.

3. Turn the bulb holder anti-clockwise and remove it.

4. Remove the bulb.

Headlamp main beam

1. Remove the headlamp. See Removing a headlamp.

2. Remove the cover.


2. Remove the cover.

3. Release the retaining clip. Turn the bulb holder anti-clockwise and remove it.

4. Remove the bulb.

Side lamp

1. Remove the headlamp. See Removing a headlamp.

2. Remove the cover.


2. Remove the cover.

3. Pull the bulb holder and remove it.

Remove the bulb.

Side repeaters
Side repeaters

1. Press the side of the cover to release the clips.

2. Remove the cover.

3. Remove the bulb and bulb holder.


3. Remove the bulb and bulb holder.

Remove the bulb.

Front fog lamps

Note: The front fog lamps are not serviceable items, please consult your dealer if these fail.

Rear lamps
Rear lamps

1. Remove the screws.

2. Lift up the luggage compartment seal.


2. Lift up the luggage compartment seal.

3. Remove the carpet.


3. Remove the carpet.

4. Remove the wing nut.


4. Remove the wing nut.

5. Remove the rear lamp and unclip the bulb holder.

Tail and Brake A
Tail and Brake A
Reverse B
Indicator C

4. Remove the bulb.

Rear fog lamps

Note: The rear fog lamps are not serviceable items, please consult your dealer if these fail.

Central high mounted brake lamp

Note: The LED board is not a serviceable item, please consult your dealer if this fails.

Number plate lamp
Number plate lamp

1. Carefully release the spring clip.

2. Remove the lamp.

3. Remove the bulb.

Interior lamp
Interior lamp

1. Carefully prise out the lamp.

2. Turn the bulb holder anti-clockwise and remove it.

3. Remove the bulb.

Reading lamps
Reading lamps

1. Carefully prise out the lamp.

2. Turn the bulb holder anti-clockwise and remove it.

3. Remove the bulb.

Luggage compartment lamp
Luggage compartment lamp

1. Carefully prise out the lamp.

2. Remove the bulb.

    See also:

    Manual transmission operation (if equipped)
    Using the clutch Manual transmission vehicles have a starter interlock that prevents cranking the engine unless the clutch pedal is fully pressed. To start the vehicle: 1. Make sure the parkin ...

    Accelerator pedal - removal and refitting
    Removal 1 The pedal can be removed once the throttle cable has been disconnected from it as described in Section 7. 2 Undo the two pedal support bracket retaining bolts and remove the pedal. Ref ...

    Timing chain and sprockets - removal and refitting
    Note: Refer to the warning at the beginning of Section 5 before proceeding. A suitable puller will be required to remove the crankshaft pulley. A new crankshaft pulley bolt, a new timing chain ten ...