Using the parking aid - Vehicles With: Rear Parking Aid

WARNING:
The parking aid does not relieve you of your responsibility to drive with due care and attention.

The parking aid is automatically activated


The parking aid is automatically activated when you select reverse gear with the ignition switched on.

You will hear an intermittent tone at a distance of approximately 150 centimetres (59 inches) between the obstacle and rear bumper and approximately 50 centimetres (20 inches) to the side. Decreasing the distance accelerates the intermittent tone. A continuous tone will start at a distance of less than 30 centimetres (11 inches) to the rear bumper.

Note: If a high pitch tone is heard for three seconds, this indicates a malfunction. The system will be disabled.

Have the system checked by a properly trained technician.

    See also:

    Exterior rear pillar trim panel (Saloon models) - renewal
    1 Remove the interior rear pillar trim panel. 2 Unscrew the three now exposed securing nuts and withdraw the exterior trim panel (see illustration). 34.2 Exterior rear pillar trim panel securing ...

    Central door locking components - operation, removal and refitting
    Note: If a central locking solenoid or motor is to be renewed due to jamming or overheating, the central locking relay must be renewed at the same time even if it is believed to be working correct ...

    Interior trim panels - general information
    1 The method of removal and refitting for most interior trim panels is self-explanatory. The panels are fixed in place either by screws, which may be concealed by plastic blanking plugs in some ca ...