Telephone commands

Phone

Your phone system allows you to create an additional phonebook. The stored entries can be dialled by voice control.

Phone numbers stored by using voice control are stored on the vehicle system and not in your phone.

Overview

The overview below shows the available voice commands. The following lists will give further information about the complete command menu in selected examples.

* Can be used as a shortcut.


* Can be used as a shortcut.

Phone functions

Dial number

Phone numbers can be dialled after giving the name tag voice command.


* Can be used as a shortcut.


* Can be used as a shortcut.

Dial name

Phone numbers can be dialled after giving the name tag voice command.

* Can be used as a shortcut.


* Can be used as a shortcut.

Redial

This function allows you to redial the last dialled phone number.


* Can be used as a shortcut.


* Can be used as a shortcut.

Mobile name

This function allows you to access phone numbers stored with a name tag in your mobile phone.

* Can be used as a shortcut.


* Can be used as a shortcut.

DTMF (Tone dialling)

This function transfers spoken numbers into DTMF tones. For example, to make a remote enquiry to your home answering machine or to enter a PIN number etc.

Note: DTMF can only be used during an ongoing call. Press the VOICE button and wait for the system prompt.

Can only be used with vehicles installed with a dedicated VOICE button.

Create a phonebook


Create a phonebook

Store name

New entries can be stored with the "STORE NAME" command. This feature can be used to dial a number by calling up the name instead of the full phone number.


Delete name


Delete name

Stored names can also be deleted from the directory.

Play directory


Play directory

Use this function to let the system tell you all stored entries.

Delete directory


Delete directory

This function allows you to delete all entries in one go.

Main settings


Main settings

Reject calls

Calls can be set to be automatically rejected using voice control.

* use this command to turn the reject mode off


* use this command to turn the reject mode off

    See also:

    Using stability control
    Note: The system will be switched on automatically every time you switch the ignition on. To turn the system off and on. See Information displays. ...

    Heater motor/fan - removal and refitting
    Removal 1 Open the bonnet, disconnect the battery and pull off the rubber seal which seals the air inlet duct to the bonnet lid when the lid is closed. 2 Prise off the five spring clips from the ...

    Vehicle identification plate
    Vehicle identification plate Vehicle identification number A Gross vehicle weight B Gross train weight C Maximum front axle weight D Maximum rear axle weight E The vehicle identification numbe ...