Specifications
General
System type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . Multi-point electronic fuel injection
Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . 1.6 litre engines from 1990
Control pressure (engine running) . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . 2.3 to 2.5 bar (33 to 36 lbf/in2)
Fuel requirement
Fuel octane rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . 95 RON (unleaded) or 97 RON (leaded)
Torque wrench setting Nm lbf ft
Fuel filter unions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . 14 to 20 11 to 15
See also:
Pistons/connecting rods - removal and refitting
Removal
1 Remove the sump, as described in Section
8, and the cylinder head, as described in
Section 7.
2 Check that the connecting rod and cap
have adjacent numbers at their big-end to
indicate ...
Heater - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Refer to Chapter 11 and remove the centre
console.
3 Working within the engine compartment,
disconnect the coolant hoses from the heater
pipe st ...
Crankshaft rear oil seal - renewal
Note: New flywheel/driveplate bolts must be
used on refitting.
1 Remove the flywheel/driveplate and the
engine adapter plate.
2 Extract the seal using an oil seal removal
tool if available. It ma ...
