Distributor lubrication - models with contact breaker distributor (Every 6000 miles or 6 months)
1 Remove the distributor cap and the rotor arm.
2 Apply a couple of drops of light oil to the felt pad in the top of the shaft.
3 Wipe clean the distributor cam, then apply a trace of high melting-point grease to the four cam lobes.
4 Refit the rotor arm and the distributor cap.
See also:
Ignition systems
The ignition system is divided into two circuits, low tension
(primary) and high tension (secondary). The low tension circuit consists of the
battery, ignition switch, primary coil windings and th ...
Carburettor (Weber 2V TLD) - removal and refitting
Caution: Refer to the
precautions in Section 1 before
proceeding.
Note: A new gasket must be used when
refitting the carburettor. A tachometer and an
exhaust gas analyser will be required to chec ...
Exhaust gas oxygen (HEGO) sensor (2.0 litre DOHC/1.6 & 1.8 litre (R6A type)
CVH) - removal and refitting
Note: Do not touch the tip of the HEGO
sensor as this will drastically shorten its
service life.
Note: A new sealing ring should be used on
refitting.
Removal
1 Ensure that the engine and the ex ...
