Roadwheel check (Every 12 000 miles or 12 months)
Check the wheel rims for distortion, damage and excessive run-out. Also make sure that the balance weights are secure with no obvious signs that any are missing.
Check the torque of the wheel bolts.
See also:
Engine Coolant Temperature (ECT) sensor - removal and refitting
Removal
1 The sensor is screwed into the cylinder
block below the inlet manifold.
2 Disconnect the battery negative lead.
3 Drain the cooling system as described in
Chapter 1.
4 Disconnect the s ...
Rear seat catch - removal and refitting
Saloon models
1 Working in the luggage compartment,
release the seat catch by pulling the release
knob, or if the cable is broken, use a
screwdriver to release the catch itself.
2 Fold the backre ...
Distributor (OHC models) - removal and refitting
Note: During production the engine ignition
timing is accurately set using a microwave
process, and sealant is applied to the
distributor clamp bolt. Removal of the
distributor should be avoided e ...
