Accelerator pedal - removal and refitting

The procedure is the same as described in Part A of this Chapter for carburettor models.

    See also:

    Exhaust emission control system components - removal and refitting
    Carburettor engines Spark delay/sustain valve Removal 1 Disconnect the vacuum lines at the valve and remove the valve from the engine. Refitting 2 When refitting a spark delay valve it must be ...

    Oil pump - removal and refitting
    Note: A suitable puller will be required to remove the crankshaft pulley. A new crankshaft pulley bolt, a new lower timing chain cover gasket, and a new oil pump gasket, must be used on refitting. ...

    Distributor (OHC models) - removal and refitting
    Note: During production the engine ignition timing is accurately set using a microwave process, and sealant is applied to the distributor clamp bolt. Removal of the distributor should be avoided e ...