Specifications

Torque wrench setting Nm lbf ft All seat belt anchor bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 to 41 21 to 30

    See also:

    Cylinder head - dismantling and reassembly
    Note: A valve spring compressor will be required during this procedure. New valve stem oil seals should be used on reassembly. 1.8 litre (R2A type) Dismantling 1 With the cylinder head removed, ...

    Crankshaft and bearings - examination and renovation
    1 Examine the bearing surfaces of the crankshaft for scratches or scoring and, using a micrometer, check each journal and crankpin for ovality. Where this is found to be in excess of 0.0254 mm (0. ...

    Ignition switch - removal and refitting
    Pre-1986 models Removal 1 Disconnect the battery, undo the screws and remove the steering column lower shroud. 2 Insert the ignition key into the lock and turn it to position I. 3 Using a flat- ...