Rear parcel shelf - removal and refitting
Removal
1 Open the tailgate fully and disengage the
parcel shelf lifting strap loops from the tailgate
retaining knobs.
2 Lift out the parcel shelf pivot pins from their notches in the support brackets and withdraw the shelf.
3 Pull each strap loop through its hole in the rear edge of the shelf by disengaging the upper and lower retaining collars.
4 The shelf brackets are secured with pop rivets which must be drilled out if the brackets are to be removed.
Refitting
5 Refitting is a reversal of removal.
See also:
Bulbs (interior lamps) - renewal
Pre-1986 models
Glove compartment lamp
1 This is simply a matter of gently pulling the
bulb from its holder.
Heater control illumination lamp
2 Slide the heater control levers to the top of
thei ...
Heater matrix - removal and refitting
Removal
1 With the heater removed from the vehicle
as previously described, extract the two
securing screws and slide the matrix out of
the heater casing.
2 If further dismantling is necessary, c ...
Exhaust gas oxygen (HEGO) sensor (2.0 litre DOHC/1.6 & 1.8 litre (R6A type)
CVH) - removal and refitting
Note: Do not touch the tip of the HEGO
sensor as this will drastically shorten its
service life.
Note: A new sealing ring should be used on
refitting.
Removal
1 Ensure that the engine and the ex ...
