Diagram 1a: 1986-on Starting, charging, and ignition (except fuel injection) all models
Diagram 1a: 1986-on Starting, charging, and ignition (except fuel injection)
all models
See also:
Carburettors (all types) - dismantling and reassembly
1 A complete strip-down of a carburettor is
unlikely to cure a fault which is not
immediately obvious without introducing new
problems. If persistent carburation problems
are encountered, it is re ...
Vacuum servo unit and linkage - removal and refitting
Removal
1 Refer to Section 12 and remove the master
cylinder.
2 On fuel-injection models unclip and lift out
the front section of the heater plenum
chamber to provide access to the connecting
li ...
Front suspension lower arm - removal, overhaul and refitting
Note: A balljoint separator tool will be
required for this operation.
Removal
1 To improve access, raise the front of the
vehicle on ramps. Do not jack the vehicle up
at this stage. Apply the han ...
