Deceleratio sensitive valve (all models with conventional braking system) - removal and refitting
Caution: Refer to the precautions in Section 1.
Removal
1 The deceleration sensitive valve is located on the left-hand side of the engine compartment (see illustrations).
23.1a Early type deceleration sensitive valve
23.1b Later type deceleration sensitive valve
2 Place a suitable container beneath the valve to catch spilt fluid, then unscrew the union nuts and disconnect the fluid pipes.
Plug the open ends of the pipes and valve to prevent fluid leakage and dirt ingress. If fluid is accidentally spilt on the paintwork, wash off immediately with cold water.
3 On early models, the valve is secured to the mounting bracket on the inner wing by a single bolt. Unscrew the bolt and remove the valve.
4 On later models, the valve is secured to the mounting bracket by a clip. Remove the clip and slide out the valve.
Refitting
5 Refitting is a reversal of removal, but note that the early type of
valve must be fitted with the cover bolts facing forwards, and the later
type of valve must be fitted with the smaller diameter stepped end
facing forwards.
6 On completion, bleed the rear hydraulic circuit.
See also:
Heater motor - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Where necessary, unclip the brake servo
vacuum hose for improved access.
3 On models from 1987, unclip the
windscreen washer hoses and wiring fro ...
Oil pump - dismantling, inspection and reassembly
1.8 litre (R2A type)
1 If oil pump wear is suspected, check the
cost and availability of new parts and the cost
of a new pump. Examine the pump as
described in this Section and then decide
whethe ...
Reference
General dimensions and weights
Dimensions
Overall length:
Saloon . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . 4467.0 mm (176.0 in)
Hatchback: ...