Deceleratio sensitive valve (all models with conventional braking system) - removal and refitting
Caution: Refer to the precautions in Section 1.
Removal
1 The deceleration sensitive valve is located on the left-hand side of the engine compartment (see illustrations).
23.1a Early type deceleration sensitive valve
23.1b Later type deceleration sensitive valve
2 Place a suitable container beneath the valve to catch spilt fluid, then unscrew the union nuts and disconnect the fluid pipes.
Plug the open ends of the pipes and valve to prevent fluid leakage and dirt ingress. If fluid is accidentally spilt on the paintwork, wash off immediately with cold water.
3 On early models, the valve is secured to the mounting bracket on the inner wing by a single bolt. Unscrew the bolt and remove the valve.
4 On later models, the valve is secured to the mounting bracket by a clip. Remove the clip and slide out the valve.
Refitting
5 Refitting is a reversal of removal, but note that the early type of
valve must be fitted with the cover bolts facing forwards, and the later
type of valve must be fitted with the smaller diameter stepped end
facing forwards.
6 On completion, bleed the rear hydraulic circuit.
See also:
General information
OHV engines
The 1.1 litre and 1.3 litre OHV engines are
of four-cylinder, in-line overhead valve type
(hence OHV), mounted transversely together
with the transmission, at the front of the car.
Th ...
Brake components check (Every 36 000 miles or 3 years)
1 Inspect the thickness of the friction linings
on the disc pads and brake shoes (as
described earlier in this Chapter) at the
intervals specified.
2 The rigid and flexible hydraulic pipes and
ho ...
Electric window components - removal and refitting
1 Disconnect the battery negative lead.
Switches
2 Prise the switch from its location using a
thin-bladed screwdriver, and disconnect the
wiring plug (see illustration).
49.2 Disconnecting the ...