Deceleratio sensitive valve (all models with conventional braking system) - removal and refitting
Caution: Refer to the precautions in Section 1.
Removal
1 The deceleration sensitive valve is located on the left-hand side of the engine compartment (see illustrations).
23.1a Early type deceleration sensitive valve
23.1b Later type deceleration sensitive valve
2 Place a suitable container beneath the valve to catch spilt fluid, then unscrew the union nuts and disconnect the fluid pipes.
Plug the open ends of the pipes and valve to prevent fluid leakage and dirt ingress. If fluid is accidentally spilt on the paintwork, wash off immediately with cold water.
3 On early models, the valve is secured to the mounting bracket on the inner wing by a single bolt. Unscrew the bolt and remove the valve.
4 On later models, the valve is secured to the mounting bracket by a clip. Remove the clip and slide out the valve.
Refitting
5 Refitting is a reversal of removal, but note that the early type of
valve must be fitted with the cover bolts facing forwards, and the later
type of valve must be fitted with the smaller diameter stepped end
facing forwards.
6 On completion, bleed the rear hydraulic circuit.
See also:
Brake disc - examination, removal and refitting
Note: From 1987, thicker brake discs were
fitted. If the later discs are fitted to earlier
models, longer wheel studs must be fitted to
accommodate the increased thickness.
Consult a dealer for fu ...
Hydraulic unit pressure switch (ABS) - removal and refitting
Note: To remove the pressure switch from the
hydraulic unit in situ, Ford tool No 12-008 or a
locally made equivalent will be required. The
switch may be removed without special tools
after removi ...
Fuel filler flap - removal and refitting
Removal
1 Open the filler flap and the tailgate or boot
lid, as applicable.
2 Remove the fuel filler cap and then remove
the screw securing the filler housing to the
fuel tank neck (see illustrat ...