Specifications
General
System type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . Single-point electronic fuel injection
Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . 1.4 litre engines from 1990
Fuel requirement
Fuel octane rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . 95 RON (unleaded)
Torque wrench settings Nm lbf ft
HEGO sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . 50 to 70 37 to 52
Fuel filter unions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . 14 to 20 11 to 15
See also:
Idle speed compensator - removal and refitting
Removal
1 The idle speed compensator is only fitted to
K-Jetronic systems from 1986 onwards and is
located in the centre of the engine
compartment bulkhead (see illustration).
19.1 K-Jetronic s ...
Starter motor brushes - renewal
1 Starter motor brush renewal is a relatively
difficult procedure, requiring skill in the use of
a soldering iron. It should also be borne in
mind that if the starter motor has been in
service lon ...
Rear tie-bar (Saloon and Estate models) - removal and refitting
Removal
1 Before attempting to remove a tie-bar, note
the location of all washers and bushes. These
control the rear wheel alignment and they
must be returned to their original locations.
2 Raise ...
