Bonnet lock - removal and refitting
Removal
1 Extract the three securing screws from the
lock and lower it until the cable can be
disconnected.
2 Withdraw the lock from below the top rail.
Refitting
3 Refit by reversing the removal operations.
See also:
Bulbs (interior lamps) - renewal
Pre-1986 models
Glove compartment lamp
1 This is simply a matter of gently pulling the
bulb from its holder.
Heater control illumination lamp
2 Slide the heater control levers to the top of
thei ...
Instrument panel components - removal and refitting
1 Remove the instrument panel.
Panel illumination and warning
lamp bulbs
2 Twist the relevant bulbholder anticlockwise
and withdraw it from the printed
circuit board on the rear of the instrument ...
Throttle cable - adjustment, removal and refitting
The procedure is similar to that described in
Part A of this Chapter for carburettor engines. ...
