Timing belt renewal - CVH engines (Every 36 000 miles or 3 years)
Refer to Chapter 2, Part B.
See also:
Throttle Position Sensor (TPS) - removal and refitting
Removal
1 Disconnect the battery negative lead.
2 Unclip and disconnect the sensor wiring
plug.
3 Remove the two securing screws, and
withdraw the sensor from the throttle valve
shaft (see illus ...
Alternator drivebelt check (Every 6000 miles or 6 months)
1 A conventional vee drivebelt is used to
drive both the alternators and water pump
pulleys on OHV and HCS engines, and the
alternator pulley only on CVH engines, power
being transmitted via a pul ...
Fuel cut-off (inertia) switch - removal and refitting
Removal
1 The fuel cut-off switch is located in the
luggage compartment, under the spare wheel
(see illustration).
18.1 Fuel cut-off (inertia) switch location (arrowed) - 1.4 CFI engine
A Reset ...
