Major operations requiring engine removal

The following work can only be carried out after removal of the engine from the car: a) Crankshaft main bearings - renewal .

b) Crankshaft - removal and refitting.

c) Flywheel - removal and refitting.

d) Crankshaft rear oil seal - renewal.

e) Camshaft - removal and refitting.

f) Timing gears and chain - removal and refitting.

    See also:

    Carbon canister-purge solenoid (models with catalytic converter) - removal and refitting
    2.0 litre DOHC models 1 The purge solenoid is located next to the carbon canister, on the right-hand side of the engine compartment. 2 Disconnect the battery negative lead. 3 Disconnect the solen ...

    Heater motor/fan - removal and refitting
    Removal 1 Open the bonnet, disconnect the battery and pull off the rubber seal which seals the air inlet duct to the bonnet lid when the lid is closed. 2 Prise off the five spring clips from the ...

    Engine - refitting (automatic transmission in vehicle)
    1 Reverse the procedure described in Section 10, noting the following points: 2 Check that the engine adapter plate is correctly positioned on its locating dowels. 3 As the torque converter is onl ...