Accelerator pedal - removal and refitting
Removal
1 The pedal can be removed once the throttle
cable has been disconnected from it as
described in Section 7.
2 Undo the two pedal support bracket retaining bolts and remove the pedal.
Refitting
3 Refitting is the reversal of removal but on
completion check the throttle cable
adjustment as described in Section 7.
See also:
Facia panels - removal and refitting
Models up to 1992
1 Note the locations of the facia panel
securing screws (see illustration).
43.1 Facia panel securing screw locations (arrowed)
A Upper facia panel
B Passenger side lower faci ...
Front hub bearings - renewal
Note: A new driveshaft nut, and a new tie-rod
balljoint split-pin must be used on refitting.
1 Remove the wheel trim and release the
staking on the driveshaft retaining nut using a
suitable punch. ...
Rear wheel cylinder (drum brakes) - removal, overhaul and refitting
Caution: Refer to the
precautions in Section 1.
Saloon, Hatchback and Estate
models
1 Chock the front wheels, loosen the relevant
roadwheel nuts, then jack up the rear of the
vehicle and support ...
