See also:

Rear hub bearings - renewal
1 Raise and support the rear of the vehicle on stands (see “Jacking and Vehicle Support”). Remove the roadwheel and release the handbrake. 2 On fuel-injected models and Van versions undo the reta ...

Thermostat - removal, testing and refitting
OHV engines Note: A new gasket must be used on refitting. Removal 1 Drain the cooling system as described in Chapter 1. 2 Slacken the clips and disconnect the hoses at the thermostat housing (se ...

Handbrake cable - adjustment
Note: Where fitted, the adjuster locking pin must be renewed on completion of adjustment. Conventional braking system (except P100 models) 1 The handbrake cable is normally self-adjusting in use ...