Throttle cable - adjustment, removal and refitting
The procedure is similar to that described in Part A of this Chapter for carburettor engines.
See also:
Front disc caliper - removal, overhaul and refitting
Caution: Refer to the
precautions in Section 1.
Removal
1 Apply the handbrake, loosen the relevant
roadwheel nuts, then jack up the front of the
vehicle and support on axle stands. (see
“Jacking ...
Engine dismantling, examination, renovation and reassembly - general
information
Dismantling
1 Refer to Chapter 2, Part A, Section 18,
paragraphs 1 to 8 inclusive.
2 A suitable selection of splined and Torx
sockets will be required to remove many of
the bolts when dismantling ...
Starter motor - testing in the vehicle
1 If the starter motor fails to operate first
check the condition of the battery.
2 Check the security and condition of all
relevant wiring.
Solenoid check
3 Disconnect the battery negative lead ...
