Electrical fault finding - general information

Refer to Chapter 12.

    See also:

    Front suspension lower arm - removal, overhaul and refitting
    Note: A balljoint separator tool will be required for this operation. Removal 1 To improve access, raise the front of the vehicle on ramps. Do not jack the vehicle up at this stage. Apply the han ...

    Glove compartment - removal and refitting
    Pre-1986 models Removal 1 Open the glovebox lid and extract the screws which hold the glovebox to the facia. 2 Remove the latch (two screws). 3 Remove the single screw inside the top of the glov ...

    Instrument panel components - removal and refitting
    1 Remove the instrument panel. Panel illumination and warning lamp bulbs 2 Twist the relevant bulbholder anticlockwise and withdraw it from the printed circuit board on the rear of the instrument ...