Speedometer cable - removal and refitting

Removal
1 Disconnect the battery and remove the instrument panel as described in Section 9.

2 Disconnect the cable from the transmission and release it from its clips and grommet.

3 Withdraw the cable through the bulkhead.

Refitting
4 Refitting is a reversal of removal. The inner and outer cables are supplied as a complete assembly.

    See also:

    Rear disc caliper - removal, overhaul and refitting
    Note: Complete dismantling of the rear caliper should not be attempted unless Ford spring compressor (tool No 12-007) is available, or unless the problems likely to arise in the absence of the too ...

    Suspension and steering
    The independent front suspension is of the MacPherson strut type, incorporating coil springs and integral telescopic shock absorbers. Lateral location of each strut assembly is by a forged or pres ...

    Sump - removal and refitting
    Note: New gaskets and sealing strips will be required for refitting, and sealing compound will be required to coat the gasket faces. Removal 1 If the engine is in the vehicle, proceed as follows, ...