See also:

Rear disc caliper - removal, overhaul and refitting
Note: Complete dismantling of the rear caliper should not be attempted unless Ford spring compressor (tool No 12-007) is available, or unless the problems likely to arise in the absence of the too ...

Front suspension lower arm (pressed steel type) - removal, overhaul and refitting
1 The pressed steel type suspension is only fitted to pre-May 1983 1.1 litre models (see illustration). 4.1 Pressed steel type lower arm components A Lower arm B Tie-bar C Retaining bolt D Ba ...

Throttle valve control motor (1.6 and 1.8 litre (R6A type) CVH) - removal and refitting
1.6 litre 1 Disconnect the battery negative lead. 2 Remove the air cleaner. 3 Disconnect the wiring connectors from the throttle valve control motor, and the throttle position sensor, pulling on ...