See also:

Engine/manual gearbox assembly - removal and separation
Note: A suitable hoist and lifting tackle will be required for this operation. 1.8 litre (R2A type) Removal 1 Proceed as described in Section 8, paragraphs 1 to 15 inclusive. 2 Working inside th ...

Fuel pump - testing
1 If the fuel pump is functioning, it should be possible to hear it “buzzing” by listening under the rear of the vehicle when the ignition is switched on. Unless the engine is started, the fuel pu ...

Bonnet lock - removal and refitting
Removal 1 Extract the three securing screws from the lock and lower it until the cable can be disconnected. 2 Withdraw the lock from below the top rail. Refitting 3 Refit by reversing the remova ...