Accelerator pedal - removal and refitting
The procedure is the same as described in Part A of this Chapter for carburettor models.
See also:
Engine Coolant Temperature (ECT) sensor - removal and refitting
Removal
1 The sensor is screwed into the cylinder
block below the inlet manifold.
2 Disconnect the battery negative lead.
3 Drain the cooling system as described in
Chapter 1.
4 Disconnect the s ...
Brake pedal - removal, refitting and adjustment
Removal
1 Working within the vehicle, remove the
under-dash cover panel.
2 Extract the spring clip which connects the
pushrod to the arm of the brake pedal.
3 Extract the circlip from the end of ...
Engine electrical systems
General information and precautions
General information
The electrical system is of the 12 volt
negative earth type, and consists of a 12 volt
battery, alternator with integral voltage
regulator, ...
