Cigar lighter - removal and refitting
Removal
1 Disconnect the battery negative terminal.
2 On pre-1986 models remove the ashtray then undo the screws and withdraw the ashtray housing. On 1986 models onwards, refer to Section 21 and remove the radio/cassette player.
3 Disconnect the wiring from the cigar lighter body.
4 Pull out the cigar lighter element.
5 Push the lighter body and illuminating ring out of their locations then separate the ring from the lighter body.
Refitting
6 Refitting is the reverse sequence to
removal.
See also:
Fuel cut-off (inertia) switch - removal and refitting
The procedure is as described in Part C of
this Chapter for models with the CFI system. ...
Rear disc splash shield - removal and refitting
Note: A suitable puller will be required to
remove the drive flange, and a new rear hub
nut must be used on reassembly.
Caution: Refer to the
precautions in Section 1.
Removal
1 Loosen the rear ...
EEC IV module - removal and refitting
Removal
1 The EEC IV module is located behind the
centre console, beneath the trim panel (see
illustration).
20.1 EEC IV module location (arrowed) 1.4 CFI engine
2 Disconnect the battery negati ...
