See also:

Crankshaft front oil seal - renewal
Note: A suitable puller will be required to remove the crankshaft pulley. A new crankshaft pulley bolt, and a new lower timing chain cover gasket, must be used on refitting. 1 The crankshaft front ...

Rear hub bearings - adjustment
Note: A new hub nut split-pin must be used on refitting. 1 Raise and support the rear of the vehicle on stands. Release the handbrake. 2 This adjustment will normally only be required if, when th ...

Boot lid lock (Saloon models) - removal and refitting
Removal 1 With the boot lid raised, remove the lock barrel retaining clip. 2 Where applicable, disconnect the operating lever from the central locking solenoid/motor, then withdraw the lock barre ...