Glove compartment - removal and refitting
Pre-1986 models
Removal
1 Open the glovebox lid and extract the
screws which hold the glovebox to the facia.
2 Remove the latch (two screws).
3 Remove the single screw inside the top of the glove compartment which holds it to the moulded bracket. Withdraw the glove compartment.
Refitting
4 Refitting is a reversal of removal.
1986 models onwards
Removal
5 Undo the two screws and remove the glove
compartment lid.
6 Remove the latch (two screws) and disconnect the lamp wiring (where fitted).
7 Undo the three screws and remove the glove compartment.
Refitting
8 Refitting is a reversal of removal.
See also:
Carburettor (Weber 2V type) - fast idle speed adjustment
1 This procedure does not apply to models
fitted with a carburettor stepper motor, for
which no adjustment is possible.
2 Check the idle speed and mixture. The idle
speed must be correct before at ...
Fuel tank - removal and refitting
The procedure is as described in Part A of
this Chapter for carburettor engines. ...
Starter motor - removal and refitting
Removal
1 Disconnect the battery.
2 Working from under the vehicle, disconnect
the main starter motor cable and the two
wires from the starter solenoid (see
illustration).
8.2 Disconnecting th ...
