Exhaust manifold nut check - RS Turbo models (Every 6000 miles or 6 months)

Check the tightness of the exhaust manifold securing nuts using a torque wrench.

    See also:

    Crankshaft rear oil seal - renewal
    Note: New flywheel/driveplate bolts must be used on refitting. 1 Remove the flywheel/driveplate and the engine adapter plate. 2 Extract the seal using an oil seal removal tool if available. It ma ...

    Engine dismantling, examination, renovation and reassembly - general information
    Dismantling 1 Refer to Chapter 2, Part A, Section 18, paragraphs 1 to 8 inclusive. 2 A suitable selection of splined and Torx sockets will be required to remove many of the bolts when dismantling ...

    Fuel tank - removal and refitting
    The procedure is as described in Part A of this Chapter for carburettor engines. ...